No water leakage Sealing material Characteristic：

1, rapid plugging, 4-6 minutes by certain pressure leakage;

2, micro expansion, good impermeability, paste sample water for 3D, not Water Leakage in 1.5MPa under pressure;

3, water leakage, corrosion resistance, good durability;

4, safety and environmental protection, no harm to the human body;

5, water leakage loss, strong adhesive force, can work with water, water plugging, and quickly;

6, the operation is simple, the site construction is only need to add water and can be used.

Using method

1, the first leakage point chisel into a bell mouth, clean up the debris or loose powder, expose the hard rough surface and water wetting.

2, take appropriate amount of this product into the mixing container, according to the king: water =1:0.3 ratio (mass ratio) add water, quickly and evenly, the environment temperature is lower, need to increase the temperature of the water and water;

3, hand mixed plugging daub bunched up into the wet material group, feel clay began to heat, quickly meet leaking direction clay pressed into the scuttling of the mouth, then immediately boarded the press flat and forced to suppress, immediately after hardening (about 2 - 3 minutes or so);

4, for soakaways, can be directly the plugging King powder into the pit, and then stay down, immediately after hardening;

5, for the serious leakage of water, the use of drainage method, the first crack, and finally the drainage hole;

6, with large area leakage, water seepage, seepage blocking point to find the point, then the cement waterproof mortar precausions treatment.

Matters needing attention：

25 kg per box, stored in a cool dry place. Open the bag after the general run out, such as the use is not over, to quickly seal the remaining part of the good. Transportation should prevent the rain, sun protection.